Bridge Offers Five Miles of Wi-Fi

May 22, 2008 | by Geoff Duncan

Larger Image | More Images

Need to connect networks at two locations but can't install a hard link? HD Communications' HD26200 wireless network bridge might do the trick...for just $318.

HD Communcations Corp. has introduced its HD26200 wireless network bridge which can latch together two locations up to five miles apart—so long as they have a direct line of sight between them. The system consists of two Ubiquiti network radios that operate in the unlicensed 2.4 GHz band; the 17dbi dual polarity antennas are configured in a wireless bridge mode that, in theory, can offer up to 50 Mbps in TCP/IP bandwidth, although actual performance will depend on installation variables. Even between the HD26200 is powered over Ethernet, so the entire installation can be handled with outdoor CAT 5 cabling. And instead of costing thousands of dollars, the bridge is available for just $318.

"Since the introduction of WiFi radios people have tried to push the range of consumer level products by adding external antennas, RF cables, and WiFi amplifier," said HD Communications CEO Don Davis, in a statement. "Now they can have an FCC certified wireless bridge that will work better, look better, is easier to configure, and easier to install for less than $320."

Although the HD26200 requires line-of-sight between the two locations, the company says it's working on bridges that don't require a line of sight between them, and hopes to have additional bridges available by the end of summer.

Post Your Comment...Comments

Bill Pringte on May 22nd, 2008 at 9:23 PM:

Cool idea. I think military grade Wireless B supports this. Surprised it took this long to come out for consumers.

The only problem is the whole line of sight thing... Won't work too well here in the Northwest.

Comment on this article




Please keep your comments relevant to this article. Email addresses are not displayed, they are only required to verify you are human.

When you submit your comment, an email will be sent to your email address with a confirmation link. Once you have clicked on that confirmation link your comment will be posted.

HTML is not allowed.